banner



How To Fix Brother P Touch Label Maker

How To Fix Blood brother Label Maker Record – 6 Mutual Problems & Solutions

The Blood brother P-affect line of label makers comes in over 70 different models ranging from hand-held models to desktop models. The hand-held characterization makers are in compact design and so that y'all can just concord them in the palm of your hand. The desktop models, yet, are larger in size and demand to exist put on a desk to brand operation and handling easier. Although there is a bully number of dissimilar models, most of the models accept the aforementioned basic operating principles. Therefore, nosotros've specially made the following table of some common issues and solutions regarding how to fix Brother label maker tape.

Common Problems & Solutions

Trouble Solution
The label is not printed after pressing the Impress key.
  • Check that the text has been entered and that the tape cassette has been properly installed with sufficient tape remaining.
  • If the tape is bent, cut off the aptitude section and thread the tape through the tape exit slot.
  • If the record is stuck, remove the record cassette and so gently pull out the stuck tape and cut information technology.
The characterization is non printed correctly.
  • Remove the label tape cassette and reinstall information technology, pressing it firmly until information technology snaps into identify.
  • If the print caput is dirty, clean it with a dry cotton swab or optional print head cleaning cassette.
A blank horizontal line appears through the printed label.
  • Some dust or grime may be on the print head. Remove the label tape cassette and use a dry cotton wool swab to gently wipe the print head clean in an up-and-downward motion.
The tape doesn't feed properly or the tape gets jammed in the characterization maker.
  • Check that the finish of the record feeds under the tape guides.
  • The cutter lever is used while printing. Exercise not bear on the cutter lever during printing.
The ink ribbon is separated from the ink roller.
  • If the ink ribbon is cleaved or damaged, replace the label tape cassette.
  • If non, leave the tape uncut and remove the tape cassette, then wind the loose ink ribbon onto the spool as shown in the figure.

Wind onto Spool

The P-bear upon characterization maker stops while press a characterization.
  • Replace the characterization tape cassette if striped tape is visible, as this indicates that you've reached the end of the tape.
  • Replace all batteries or direct connect the AC adapter to the P-touch label maker.

Every once in a while you meet the same or like problems when press a label with Brother P-touch label maker, you can refer to the in a higher place tabular array of vi mutual issues and solutions on how to fix Brother label maker tape. We hope you notice this article of value and that the solutions listed above could assistance yous solve the common problems to fix Brother characterization maker record. Moreover, you lot can as well choose TIANSE to buy uniform label tapes for your Brother P-touch line of label makers from a diverseness of label tapes in different sizes, colors and styles.


Post time: Jun-11-2019

How To Fix Brother P Touch Label Maker,

Source: https://www.tianseoffice.com/blog/how-to-fix-brother-label-maker-tape

Posted by: gillhamboyaceing.blogspot.com

0 Response to "How To Fix Brother P Touch Label Maker"

Post a Comment

Iklan Atas Artikel

Iklan Tengah Artikel 1

Iklan Tengah Artikel 2

Iklan Bawah Artikel